M-Audio Studiophile LX4 2.1 Active Studio Monitor System
Studiophile LX4s are the world's first reference monitors that allow you to expand from 2. 1 to 5. 1 seamlessly on demand. The LX4 2. 1 System gives you two transparent satellite speakers and a powerful subwoofer with integral crossover for a sound that surpasses mere stereo. When you're ready to mix and experience multi-channel audio, just add another three perfectly matched satellites with the optional LX4 5. 1 Expander for a complete professional-sounding 5. 1 surround system. The LX4s' performance also makes them great all-around real-world reference monitors in both 2. 1 and 5. 1 configurations. The LX4s are so compact that you can fit them just about anywhere. Passive design also means that there's no power or line-level signals to route, making setup and positioning a breeze. Studiophile LX4 - expand on demand. Highlightsfull-fidelity 2. 1 monitoring4î polypropylene low-frequency satellite drivers1î mylar high-frequency satellite drivers8î subwoofer with 6 integral power ampssmall enough to fit anywhereported enclosures for optimal fidelityTechnical SpecificationsType: 3-way studio reference with subwoofer - 2. 1 System, expandable to 5. 1Subwoofer Driver: 8 inch diameter, specially-developed curved-profile pulp cone, high-temperature voice coil and damped closed cell foam surround - designed for sub-frequency pressure levels with very high efficiency and extremely low distortionLF Driver: 4-inch dia. , magnetically-shielded with curved mineral-filled polypropylene cone, high temperature voice coil and damped closed cell foam surroundHF Driver: 1-inch dia. , magnetically-shielded; specially-shaped mylar domeFrequency Response: 40Hz - 20kHzCrossover Frequencies: 2. 9kHz and 140HzRMS SPL @ 1 meter: 105dBSubwoofer Amplifier Power: 60WSat Amplifier Power: 27W (Five Sat Amplifiers)Dynamic Range: >100dBS/N Ratio: >100dB below full output, 20kHz bandwidthInput Connectors: Six TRS balanced/unbalanced input connectors (L, R, SL, SR, C & LFE)Polarity: Positive signal at + input produces outward low-frequency cone displacementInput Impedance: 20k ohms balanced, 10k ohms unbalancedInput Sensitivity, Sat: Input 100 mV pink-noise produces 90dBA output SPL @ 1meter w/ vol ctl at max settingInput Sensitivity, LFE: input 50mV pink-noise produces 90dBA output SPL @ 1meter w/ vol cntrl at max settingProtection: RF interference, output current limiting, over temperature, turn on/off transient, subsonic filter, external main fuseIndicator: Green-Orange Power/Protection indicator (Back Panel). When the power switch is switched to ON, the LED will glow Green. When the Protection circuitry of power amplifiers is turned on , the LED will glow Orange. At the same time, the output level will reduce 12dB. Power Requirements: Dual-voltage (selectable by rear-panel switch) for either 115V/~60Hz, 230V/~50Hz; powered via detachable 3-circuit line cordCabinet: vinyl-laminated MDFDimensions, Subwoofer: 15. 75 (H) x 9. 75 (W) x 12. 25 (D)Dimensions, L & R: 8. 5 (H) x 5. 75 (W) x 6. 75 (D)Weight: 14 kg / unit* All specifications subject to change without notice
