Event 20/20BAS V3 Studio Monitor, Single
The Event 20/20BAS speaker incorporates a number of fundamental improvements over the original model while remaining true to its character and performance strengths.
The original transducer design and cabinet volume have been maintained, however the high and low frequency amplifiers, cabinet bracing and overall construction have been revolutionized to improve audio characteristics, increase dynamics and extend reliability.
Event's engineering team used ideas and technologies from its flagship Opal speaker in order to achieve performance in keeping with the company design philosophy of high output, low distortion and excellent dynamics.
Fully discrete Class AB amplifiers for the tweeter and woofer provide up to 250 watts of burst power with less than .01% Total Harmonic Distortion (THD). This more than doubles the power provided by the original 20/20bas amplifier design with less than half the distortion. Sustained high output performance is ensured through a new oversized toroidal power supply that can ensure sustained extreme low frequency reproduction. The new low frequency amp can deliver up to 250w of peak power into the woofer. This gives you the BOOM... the definition in the bottom end that you're looking for.
Get yours today; with the Sam Ash Direct 45/60day return/ price protection policy, we assure the best price and a fast, free delivery.
*Price is for 1 Speaker
System
Frequency Response - 35Hz - 20kHz ±2dB
Crossover Frequency - 2300Hz
3rd Harmonic Distortion @ 90dB SPL, 1m, 500-7kHz - 0.08%
3rd Harmonic Distortion @ 90dB SPL, 1m, 200 - 20kHz - 0.2%
3rd Harmonic Distortion @ 90dB SPL, 1m,<200Hz - 1.5%
Acoustic Output - SPL @ 1m, Long term (80Hz - 20kHz) - 105dB
Acoustic Output - SPL @ 1m, Peak (80Hz - 20kHz) -108dB
Signal Input - XLR (balanced)
Low Frequency Transducer
Piston Diameter - 180mm (7.1")
Voice Coil Configuration - High temperature single coil
Voice Coil Diameter - 38mm (1.5")
Former Material - High-strength Polyamide - Glass Fiber
Magnet Type - Ferrite
Cone Type - Mineral Filled Polypropylene
Magnetic Shielding - Bucking magnet and steel cap
High Frequency Transducer
Dome Diameter - 25.4mm (1")
Voice Coil Diameter - 25mm (0.98")
Magnet Type - Ferrite
Dome Type - Silk
Gap Design - Ferrofluid Cooled
Magnetic Shielding - Bucking Magnet
Amplifier - Low/high frequency
Frequency Response - 20Hz - 20kHz(±0.2dB)
Operating Band Pass - 20Hz - 2400Hz (LF)/2400Hz - 20kHz (HF)
Total Harmonic Distortion - 0.01% 120 Watts into 4 Ohm Load
Long Term Power @ 4 Ohms - 80 Watts
Burst Power @ 4 Ohms - 120 Watts
Output Topology - Class AB
LF Trim - Constantly variable ±3dB
HF Trim - Constantly variable ±3dB
Subsonic Filter – (-3dB @ 30Hz)
Driver Protection - Current Limiting
Temperature Protection - Thermal Cut-Off Switch
Indicators - Event badge 'On' mode
Cooling - Convection - Aluminum Heat Sink
Power Requirements - Voltage selector 110-120V or 220-240V, 50/60Hz, 180VA Power via detachable 3 circuit IEC type linecord
