Event 20/20BAS V3 Studio Monitor, Single

The Event 20/20BAS speaker incorporates a number of fundamental improvements over the original model while remaining true to its character and performance strengths.

The original transducer design and cabinet volume have been maintained, however the high and low frequency amplifiers, cabinet bracing and overall construction have been revolutionized to improve audio characteristics, increase dynamics and extend reliability.

Event's engineering team used ideas and technologies from its flagship Opal speaker in order to achieve performance in keeping with the company design philosophy of high output, low distortion and excellent dynamics.

Fully discrete Class AB amplifiers for the tweeter and woofer provide up to 250 watts of burst power with less than .01% Total Harmonic Distortion (THD). This more than doubles the power provided by the original 20/20bas amplifier design with less than half the distortion. Sustained high output performance is ensured through a new oversized toroidal power supply that can ensure sustained extreme low frequency reproduction. The new low frequency amp can deliver up to 250w of peak power into the woofer. This gives you the BOOM... the definition in the bottom end that you're looking for.

Get yours today; with the Sam Ash Direct 45/60day return/ price protection policy, we assure the best price and a fast, free delivery.

*Price is for 1 Speaker

System

Frequency Response - 35Hz - 20kHz ±2dB

Crossover Frequency - 2300Hz

3rd Harmonic Distortion @ 90dB SPL, 1m, 500-7kHz - 0.08%

3rd Harmonic Distortion @ 90dB SPL, 1m, 200 - 20kHz - 0.2%

3rd Harmonic Distortion @ 90dB SPL, 1m,<200Hz - 1.5%

Acoustic Output - SPL @ 1m, Long term (80Hz - 20kHz) - 105dB

Acoustic Output - SPL @ 1m, Peak (80Hz - 20kHz) -108dB

Signal Input - XLR (balanced)

Low Frequency Transducer

Piston Diameter - 180mm (7.1")

Voice Coil Configuration - High temperature single coil

Voice Coil Diameter - 38mm (1.5")

Former Material - High-strength Polyamide - Glass Fiber

Magnet Type - Ferrite

Cone Type - Mineral Filled Polypropylene

Magnetic Shielding - Bucking magnet and steel cap

High Frequency Transducer

Dome Diameter - 25.4mm (1")

Voice Coil Diameter - 25mm (0.98")

Magnet Type - Ferrite

Dome Type - Silk

Gap Design - Ferrofluid Cooled

Magnetic Shielding - Bucking Magnet

Amplifier - Low/high frequency

Frequency Response - 20Hz - 20kHz(±0.2dB)

Operating Band Pass - 20Hz - 2400Hz (LF)/2400Hz - 20kHz (HF)

Total Harmonic Distortion - 0.01% 120 Watts into 4 Ohm Load

Long Term Power @ 4 Ohms - 80 Watts

Burst Power @ 4 Ohms - 120 Watts

Output Topology - Class AB

LF Trim - Constantly variable ±3dB

HF Trim - Constantly variable ±3dB

Subsonic Filter – (-3dB @ 30Hz)

Driver Protection - Current Limiting

Temperature Protection - Thermal Cut-Off Switch

Indicators - Event badge 'On' mode

Cooling - Convection - Aluminum Heat Sink

Power Requirements - Voltage selector 110-120V or 220-240V, 50/60Hz, 180VA Power via detachable 3 circuit IEC type linecord